Screeny pi2/20/2023 For reference, here’s the LCD35-show script I used, in the state it was in at the time of writing. Enabling the 3.5” displayĮach of the following steps is based on a set of commands in the original script. I still need to take off the protective film. Below are my notes taken during the process.Īfter the screen and case are installed. Additionally, the scripts do much more than they need to.Īs a second attempt, I read through the script and applied the changes manually based on my understanding of what was needed to enable the LCD. However, the new files are based on older versions of Raspbian. The overwritten files are based on the ones provided by Raspbian, so ideally not much should be changing. I found out the scripts mess with a number of system files, overwriting configurations that are integral to the operation of the Pi. On my first attempt, I simply ran the relevant script ( LCD35-show) as requested, but I ended up not being able to connect to my WiFi anymore! It turns out this LCD, and many similar ones, ask you to enable the LCD via scripts in the LCD-show project. The installation of the hardware was straightforward, but setting up the Pi to display onto the new LCD didn’t go so well. The idea was to add a GUI application onto the Pi, which had until now been acting as a headless web and application server. The display connects via the GPIO pins and fits neatly onto the form factor of the Raspberry Pi 3. I recently bought a 3.5” TFT touchscreen display for my Raspberry Pi. Setting up an LCD screen on the Raspberry Pi, 2019 edition Setting up an LCD screen on the Raspberry Pi, 2019 edition
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |